Помощь в настройке модема и связи

[marsh snake]

собственно лог (FCS Errors :expl: :expl: :expl: )

ZyXEL MODEMS LINK STATUS REPORT

Chars Sent 3967960 Chars Received 59830103
Octets Sent 3286695 Octets Received 56029939
Blocks Sent 46790 Blocks Received 222996
Blocks Resent 32 Max Outstanding 8
Max Block Size 256 Retrains Requested 1
Link Duration 231 Retrains Granted 0
FRN Requested 26 FRN Granted 18
FCS Errors 5274 Round Trip Delay 6
Xmitter Underrun 0 Receiver Overrun 0

Last Speed/Protocol T28800/R50666/ARQ/V.92/V44

Disconnect Reason DTR dropped

OK
OK

ZyXEL MODEMS PHYSICAL LAYER STATUS REPORT

Modulation mode = V.92
Tx Carrier = 1829 Hz Rx Carrier = 0 Hz
Tx Baud Rate = 3200 Baud Rx Baud Rate = 8000 Baud
Tx Bit Rate = 28800 bps Rx Bit Rate = 50666 bps
Tx Power = -17.00 dBm Rx Level = -21.63 dBm
Phase Jitter = x.x degree Frequency Offset = x.x Hz
SNR = 52.13 dB Round Trip Delay = 6.18 ms
Near End Echo = x.x dB Eye Quality Measure = 0039
Nonlinear Encoder = ON DPCM PCM Coding = A Law
Tx Shaping = Exp APCM Codec Type = A Law
Trellis Encoder = 16 state Digital PAD Loss = 0.00 dB
Tx Filter Index = 0 TRN1d RMS value = 2000
Tx Precoder Coefficients = FF70 0021 0009 FFCA FFFC 001E
Data Frame Intervals RBS Status = I0:N I1:N I2:N I3:N I4:N I5:N

OK


-0| = = = = = = = = = = = = = = = = = H00:E39E H01:E3AF
-2| = = = = = = = = = = = = = = = = = = = H02:E39E H03:E35C
-4| = = = = = = = = = = = = = = = = = = = = H04:E336 H05:E386
-6| = = = = = = = = = = = = = = = = = = = = = H06:E368 H07:E355
-8| = = = = = = = = = = = = = = = = = = = = = H08:E315 H09:E349
-10| = = = = = = = = = = = = = = = = = = = = = H10:E33C H11:E355
-12| = = = = = = = = = = = = = = = = = = = = = H12:E301 H13:E308
-14| = = = = = = = = = = = = = = = = = = = = = H14:E322 H15:E35C
-16| = = = = = = = = = = = = = = = = = = = = = H16:E37A H17:E2ED
-18| = = = = = = = = = = = = = = = = = = = = = H18:E222 H19:E0D4
-20| = = = = = = = = = = = = = = = = = = = = = H20EBD
-22| = = = = = = = = = = = = = = = = = = = = = 0000 0085 0000 00B1 0000 00B1
-24| = = = = = = = = = = = = = = = = = = = = = 00B1 0228 0000 0212 0000 01F3
-26| = = = = = = = = = = = = = = = = = = = = = 0001 0001 0001 0000 000F 000F
-28| = = = = = = = = = = = = = = = = = = = = = AGC: 2.25 dB/0000 /0001
-30| = = = = = = = = = = = = = = = = = = = = = IMD: 0016 /0000
dB +-------------------------------------------- Echo Pwr: -22.98/ -20.71
F 0 0 0 0 0 1 1 1 1 1 2 2 2 2 2 3 3 3 3 3 3 L1 Power: -15.89/ -13.63
R 1 3 4 6 7 0 3 5 6 9 1 2 5 7 8 0 1 3 4 6 7 L2 Power: -21.98/ -19.63
E 5 0 5 0 5 5 5 0 5 5 0 5 5 0 5 0 5 0 5 0 5 S/N: 31.89
Q 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 S/E: 1.00 dB/ 1.12
OK

OK

ZyXEL MODEMS V.9x CAPABILITY REPORT

Local Modem V.9x Capability = V.92 / APCM
Remote Modem V.9x Capability = V.92 / DPCM
Local Modem PSTN Connection = Analogue
Remote Modem PSTN Connection = Digital
Local Modem Probing Report = V.92 / 3429
Remote Modem Probing Report = V.90 / 3200


OK

ZyXEL MODEMS V.9x POWER MANAGEMENT REPORT

DPCM nominal tx power for phase 2 : -9.00 dBm
DPCM actual tx power for phase 2 : -15.00 dBm
Maximum DPCM tx power for phase 3 : -12.00 dBm
Maximum DPCM tx power measured at : Codec
Digital PAD loss : 0.00 dB
IMD value measured at phase 2 : 0016
DPCM tx power reduction for IMD : 0.00 dB
APCM receive power at Phase 2 : -21.98 dBm
APCM receive power at TRN1d : -21.63 dBm
APCM receive power at Data State : -21.63 dBm
----------------------------------------------------------------
DPCM Terminal tx power : -12.29 dBm
DPCM Codec tx power : -12.29 dBm

OK